184112/0120- 85 GBIssue 3.98replaces 11.94Hydraulic Power Packs PO-4Operating InstructionsHydraulic ToolsPO_A1_1.TIF
101 Motor unit with plastic hood 8 Remote control2 Plastic oil tank 10 Connection taphole G 1/43 Pressure limiting valve 11 Thread G 1/4 for pressure
21 Basic operation and designated use of the machine1.1 The machine has been built in accordance with state-of-the-art standards and the recognizedsa
33.2 Before starting up or setting the machine in motion and during operation of the machine makesure that nobody is at risk.3.3 Before transporting t
45 Safety instructions for hydraulic hosesAll instructions to safe use of hydraulic hoses can be found in the booklet HR 1495 35 219 deliveredwith the
56.1.2.2 ConnectionRemove the locking cap at connection A of the valve block (13) and screw in hose connectionnipple. Connect pipe or hose to cylinder
66.3 Electric controlThe 3-step switch is located on the side of the plastic housing.- Top position - position I the motor is started.- Centre positio
78 OptionThe equipment described below is not part of the standard scope of supply, but special equipmentwhich is to be purchased separately.8.1 Press
89.3 Preventive MaintenanceThe oil tank must principally be cleaned with each oil change.To clean the oil tank, the mounting screws on the oil tank co
93000 230V/50Hz 1~ 0,55 ND 2,1; HD 0,24 ca. 5 l G 1/4ca. 4 lrpm Voltage Power Oil delivery Oil capacity connection(kW) (l/min) Usable oil capacity thr
Comments to this Manuals